Supports one or more layers of poly in front of walls.
PolyHanger #1 slips behind wall molding and is supported by the vertical leg of the molding. PolyHanger 1 will also support poly in front of masonry or paneling by nailing into a joint which can be easily patched after tear down. Box contains 100 units.
Benefits of PolyHanger #1:
- Eliminates damage to wall surfaces
- Simple to install, remove and reuse on the next job!
- Increases production of hanging poly sheeting
- Eliminates using spray glue to support poly sheeting
- Prevents poly from falling down
Installation Instructions
Install PolyHangers approximately 3' apart. Hang the poly sheeting on the prong keeping the top of the poly just below the wall molding. Complete the containment by taping between the poly and the molding and by taping over the prong.
PolyHanger 1 can be used to support poly in front of masonry by nailing in a joint using a tension pin (i.e., tempered steel molding nail available at drywall supply houses).
PolyHanger 1 is removed by gently pulling down on the outer tip of the wall molding which causes the back vertical leg to rotate away from the wall and PolyHanger 1 can be slid downward.
